Changing Line Type - Ricoh Aficio 340 System Settings

CHANGING LINE TYPE

The optional ISDN unit is required to use this function.
This machine comes with a single An-
alog (PSTN) line connection for G3
communication as standard. If you
install the ISDN Unit option, an extra
digital (ISDN) line connection for
both G3 and G4 communication be-
comes available.
When you use G4, press the { { { { F4} } } } key
to lit the lamp.
G4 is selected when this key is lit, G3
is selected when it is not lit.
Press the key once to switch between
G3 and G4.
Limitation
Under the operation procedure for
transmission, you can select the
line type if dialing with the num-
ber keys or Chain Dial.
- To Switch to G3 - - -
If the { { { { F4} } } } key is lit, press it once to
switch to G3.
nicating File File
Start TX File TEL
Manual RX Status Mode
F1 F2 F3
01 02 03
- To Switch to G4 -
- -
If the { { { { F4} } } } key is not lit, press it once
to switch to G4.
- Which line is used for G3 -
- -
ISDN lines can be used for G3 com-
munication as well as G4 communica-
De
tions, so this machine is set by default
Su
to use the ISDN line for both G3 and
F4 F5
G4 transmissions. If you wish to use
04 05 06
ND2L04E1
the Analog (PSTN) line for G3 trans-
missions, please contact your service
representative.
CHANGING LINE TYPE
nicating File File
Start TEL
TX File
Manual RX Status Mode
F1 F2 F3
01 02 03
Limitation
If you select G4 mode, JBIG com-
pression is not available.
transmissions?
Note
When you use G3 with ISDN, you
can set the subaddress.
De
Su
F4 F5
04 05 06
ND2L04E1
41
2