Resetting And Setting The Statistics - Siemens SIPROTEC 7SJ62 Instruction Manual

From the
Device Front
:
From PC with
®
DIGSI 4
7.1.2.2

Resetting and Setting the Statistics

From the
Device Front
7SJ62 Manual
C53000-G1140-C121-1
With a device ready for operation, first press the
The first menu item $QQXQFLDWLRQ is marked.
key to enter the $1181&,$7,21 sub-menu (see Figure 7-1).
Press the
key to select the item 6WDWLVWLF, and switch to the list of statistics values
Use the
key. The 67$7,67,& list appears. See figure 7-15.
using the
67$7,67,&6

Σ ,D
Σ ,E
Etc.
Figure 7-15 Statistics Viewed from the Front Display
Under Annunciation (Figure 7-2), the statistics can be found by double clicking. Dou-
ble click on 6WDWLVWLF. The sub-menus 6WDWLVWLF and 6HW 3RLQWV 6WDWLV
WLF appear in the data window. By double clicking on one of the two alternatives, the
associated contents are displayed in another window. See Figure 7-16.
®
Figure 7-16 DIGSI 4 List of Statistic Values
The statistics are secured against a loss of power supply voltage. The values can,
however, be set to zero, or to any desired value within the setting limits.
In the 67$7,67,& sub-menu, select the value to be set by using the
press the key. See Figure 7-17 for an example of changing the operating hours
ENTER
counter. After a password is entered, the cursor blinks and the number value is high-
lighted in a box. The number can be overwritten using the number keys. If the new val-
ue is outside of the allowable range, either above or below, then the maximum or min-
imum limit value appears at the bottom edge of the display. Confirm the change with
the key.
ENTER
MENU

N$
N$
Operators Tools
key. The 0$,1 0(18 appears.
key, and then
7-13