Other Commands - Siemens SIPROTEC 7SJ62 Instruction Manual

Operators Tools
7.3.9

Other Commands

7-50
Table 7-4 Possible Control Messages
Message Text
&KHFNLQJ ,QWHUORFN Command is sent to the central unit to check system interlocking
6HWWLQJV DUH 2.
7LPH /LPLW ([SLUHG Parameter change was interrupted because time expired
7HUPLQDWHG3LFNXS
5HVWRUH 3DUDPHWHUV As a reaction to a fault recognized during parameterization, the last
3OHDVH :DLW«
&KHFNLQJ 6HWWLQJV
6ZJU )HHGEDFN 2.
6ZJU )HHGEDFN )DLO Return message: destination not reached
&KDQJH 5HMHFWHG
&RQWURO 2.
9DOXH ,QFRUUHFW
The device is equipped with a serial interface for connection to SCADA. From there,
the device can receive standardized commands (according to the supported protocol)
and transmit them to the respective switching devices, or activate internal functions,
e.g. block inputs/outputs or set tags (manual overwrite), or release processing of func-
tions in the CFC. This command processing is determined during project planning and
configuration of the matrix.
n
Message Cause
Parameter change was correctly accepted
Parameter change interrupted because a fault became active dur-
ing parameterization
active parameter set is activated again
Initiated process running and requires some time
The changed parameters are tested before acceptance
Return message: destination reached
Parameter change was rejected (e.g., because time expired, or ab-
normal occurrence during parameterization)
Positive conclusion message for commands
Plausibility error in command
7SJ62 Manual
C53000-G1140-C121-1