Siemens SIPROTEC 7SJ62 Instruction Manual page 358

Operators Tools
Figure 7-40.
:
From PC with
®
DIGSI 4
7-36
key, highlight the menu item 7HVW'LDJQRVH, and then press the
Using the
key to enter sub-menu. 7(67',$*126( will appear at the top of the menu.
At this point, highlight the menu item 7HVW (QDEOH using the
key to enter sub-menu. 7(67 (1$%/( will appear at the top of the menu. See
the
7(67 ',$*126(

'HYLFH 5HVHW
!7HVW (QDEOH
%ON 'DWD 7UDQV²!
+DUGZDUH 7HVW ²!
6HW5HVHW
6,(0(16 ,QWHUQ
Figure 7-40 Applying Test Mode from the Operator Control Panel
To start Test mode, press the
and confirm with the
ENTER
Use the and keys to select the desired mode, and press the
tion "$UH \RX VXUH"" is displayed. Highlight the desired response and press the
key. If the mode is changed, the device responds with the message "&RQWURO
ENTER
([HFXWHG".
key to return to the 7(67',$*126( level; press the
Use the
the 0$,1 0(18.
The procedure for changing the Block Data Transmission mode is the same. See Fig-
ure 7-41 (simplified).
7(67',$*126(

!%ON 'DWD 7UDQV²!
+DUGZDUH 7HVW ²!
Figure 7-41 Applying a Block of Data Transmission from the Front Panel (simplified)
The settings for the test mode and the data transmission block are normally 2)). Def-
initions:
− 7HVW PRGH – With the 21 setting, the "test mode"-bit is transferred for messages
compatible with IEC 60 870–5–103.
− 'DWD6WRS
– With the 21 setting, no messages or measured values are trans-
ferred ("transfer block").
Click on 'HYLFH in the menu bar to reach the commands %ORFN 'DWD 7UDQVPLV
VLRQ and 7HVW 0RGH. See Figure 7-42.

²! 
7(67 (1$%/(
²! 


!7HVW PRGH

²! 

key, enter the password for test and diagnostics,
ENTER
key. A new window appears with the options 21 and 2)).


%/. '$7$ 75$16


!'DWD6WRS
key, and then press
2))
key. The ques-
ENTER
key to return to
MENU
2))
7SJ62 Manual
C53000-G1140-C121-1