Operation Using Digsi ® 4 - Siemens SIPROTEC 7SJ62 Instruction Manual

Initial Inspections
3.3.2 Operation Using DIGSI
®
DIGSI 4 Operator
Control Panel
3-8
®
4
®
DIGSI 4 has the typical PC application Windows operating environment to guide the
user. The software has a modern, intuitive, user-interface. Further details are found in
Section 4, as well as in the DIGSI
Some applications of DIGSI
surement values, reading messages in the Event Log, and setting the clock. The han-
dling of the operator control windows of DIGSI
the simple examples as descibed below. To perform the steps in the examples, first
®
connect the SIPROTEC
with the equipment. To accomplish this task:
q
Establish a physical connection between a serial interface of the PC and the oper-
ating serial interface of the device on the front panel.
q
®
Open the DIGSI 4 application in the PC.
q
Generate a new project by clicking on )LOH → 1HZ in the DIGSI
bar.
Figure 3-4 Dialog box to Open a New Project
q
Enter a name for the new project in the 1DPH entry field (e.g. test 1) and close the
box with 2..
q
Select )ROGHU by clicking on the item in the newly opened dialog field. Then click
on ',*6, ! 'HYLFH 3OXJ
shown in Figure 3-6.
®
4 handbook "Device Operation".
®
4 are described below. They include viewing the mea-
®
4 can be learned quickly by following
4 device to the PC and match the DIGSI
3OD\ . The Plug & Play dialog box opens, as
®
4 interface data
®
4–Manager menu
7SJ62 Manual
C53000-G1140-C121-1