Section 1: Introduction; Relay Menus; Operation Guide; User Interface Operation - Siemens 7SR45 Argus User Manual

Section 1: Introduction

1.1

Relay Menus

1. Setting Mode – This mode allows the user to view and change settings in the relay.
2. Instrument Mode – This mode allows the user to view the conditions of the relay i.e. Current, IO
status, and Misc. status.
3. Fault Data Mode – This mode allows the user to view fault records.
If the password is configured, the user can only view all the menus without entering a password. Further
actions are permitted if the correct password is entered.
Relay Identifier

Setting Mode

1.2

Operation Guide

1.2.1

User Interface Operation

Figures 1.3 show the basic menu structure diagram and display the main modes:
• SETTING MODE
• INSTRUMENT MODE
• FAULT DATA MODE
When the relay is shipped from the factory all stored data is cleared and the password is set to NONE.
When the relay is energized for the first time, the following message is displayed:
1.3 Setting Mode
The Setting Mode is reached by pressing the READ DOWN▼ or by pressing ENTER key from the Relay Identifier
Screen.
Once the Setting Mode is reached, the user can navigate into the settings mode sub-menus.
Each sub-menu contains the configurable settings of the relay in separate groups. The sub menus are accessed
by pressing the TEST/RESET► key. Press ▲ or ▼ keys to scroll through the first and last settings. If the keys
are pressed further from the first and last settings sub menu, it exits from the sub menu and returns to the
previous menu.
© 2018 Siemens Protection Devices Limited
Instrument Mode
Figure 1-1 Menus
Figure 1-2 Relay Identifier Screen
Chapter 2 - 7SR45 Settings & Instrument Guide
Fault Data
Mode
Chapter 2 Page 3 of 9