Siemens SIPROTEC 7SJ62 Instruction Manual page 144

Functions
Text Values
Numerical Values
(including ∞)
Confirmation
6-4
Settings are selected using the
user is prompted for a password. The user should enter Password No. 5 and then
press the ENTER key. The current value of the setting appears in a text box, with a blink-
ing text insertion cursor.
Note:
The factory default password is 000000.
A text setting may be modified using the
options.
A numerical setting may be modified by overwriting the current value using the numer-
ical keypad. See Figure 6-3. A value of " infinity " may be entered by pressing the dec-
imal key twice. The "∞"−symbol will appear in the display.
If the number entered is not within allowable limits, the maximum or minimum allow-
able value will appear in the lower portion of the display. To enter a new, allowable val-
ue, the key should be pressed again.
ENTER
Note that measured values and limit values must be entered in secondary quantities
when using the front control panel of the device.
Any modification to a setting value must be confirmed by pressing the
blinking asterisk is an indication that setting modification mode is still open. Other
modifications can be made to settings, even in sub-menus (if present), as long as set-
ting modification mode is still open. The actual modification of settings occurs once
setting modification mode is closed (see below, "Exiting the Setting Modification
Mode").
36<67(0 '$7$

!9QRP 35,0$5<
! !N9
3: 6HWWLQJV"


9QRP 35,0$5<
36<67(0 '$7$

 9QRP 35,0$5<
N9
> > >
Figure 6-3 Example of Setting Modification Using the Front Control Panel
and keys. When the
and keys to select one of two or more
Example for numerical setting:

ENTER
Enter password No. 5 and confirm with
ENTER
Enter the new value and confirm with


The modified setting value appears in the
[
list; a blinking asterisk in the title bar indi-
cates setting modification mode is still
open.
ENTER key is pressed, the
ENTER key. A
ENTER
7SJ62 Manual
C53000-G1140-C121-1