Siemens SIPROTEC 7SJ62 Instruction Manual page 122

Configuration
Preset Configura-
tions
Preset Configuration for LED Display
Table 5-4
LED Descriptive Text
LED 1 Relay Tripped
LED 2 Pickup Phase A
LED 3 Pickup Phase B
LED 4 Pickup Phase C
5-28
Any new user defined information is also shown in the display once loaded into the
®
relay from DIGSI 4.
When selecting the 0$6.,1* ,2 menu, either binary inputs, LEDs, or binary out-
puts may be selected. Selection of binary inputs is illustrated in Figure 5-27.
0$6.,1* ,2

!%LQDU\ ,QSXWV
!/('
%LQDU\ 2XWSXWV ²!
Figure 5-27 Reading the Configuration in the Display
Information regarding a binary input may be displayed by using the navigation keys to
select the binary input. See Figure 5-28.
%,1$5< ,1387


!!5HVHW /(' 63

6WDWXV DW 7HUPLQDO
Figure 5-28 Selection of Binary Input 2
In Figure 5-28, information is displayed regarding binary input 2. The display for binary
input 2 indicates that it is configured as the acknowledgment of LEDs using a single
point indication with voltage active (High). The present conditions of binary input 2 is
also given as 0 (not active). If binary input is active, a 1 is displayed.
Assignment of LEDs may be indicated at the relay, itself, using a replaceable labeling
strip with plain text on the front panel located, directly next to the LEDs.
The pre-set configurations of the binary inputs and outputs are shown in the overview
circuit figures (Appendix A.2).
The preset configurations for the LED displays upon relay delivery are listed in the fol-
lowing table.
Brief Text
Relay Tripped
Non-Directional Phase A
Directional Phase A
Non-Directional Phase B
Directional Phase B
Non-Directional Phase C
Directional Phase C

²! 
%,1$5< ,13876

²! 
!%LQDU\ ,QSXW ²!

!%LQDU\ ,QSXW ²!
+

Message #
511 One the protective functions initiated a trip.

Pickup by Aφ Element
 

Pickup by Bφ Element
 

Pickup by Cφ Element
 

²
²
Comments
7SJ62 Manual
C53000-G1140-C121-1