Table of Contents
Advertisement
SYSTEM SETTINGS►SYSTEM SETTINGS
Protocol Settings
Select the general network settings.
The TCP/IP information can be set.
TCP/IP
IPv4 Settings
When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine.
DHCP
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol) v6.
When this setting is enabled, it is not necessary to manually enter an IP address.
If DHCP/BOOTP is used, the IP address assigned to the machine may change automatically. If the IP address changes,
printing will not be possible.
IPv4 Address
Enter the IP address of the machine.
Subnet Mask
Enter the IP subnet mask.
Default Gateway
Enter the default gateway address.
IPv6 Settings
When using the machine on a TCP/IP (IPv6) network, use this setting to configure the IP address of the machine.
IPv6
Enable this setting.
DHCPv6
Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol) v6.
When this setting is enabled, it is not necessary to manually enter an IP address.
Manual Address / Prefix Length
Enter the IP address and the prefix length (0 to 128) of the machine.
Default Gateway
Enter the default gateway address.
• If DHCPv6 is used, the IP address assigned to the machine may change automatically. If the IP address changes, printing
will not be possible.
• In an IPv6 environment, the machine can use LPD or IPP protocol.
MTU Settings
Set the maximum data size that can be forwarded.
SMB Settings
Set the version of SMB protocol that is used for functions such as Scan to Network Folder.
Use this setting to connect to a device that cannot automatically change the SMB protocol version, or when there is a
problem in the connection with another device due to different versions.
Set the version to SMB2.0, SMB2.1, or SMB3.0.
• One of the settings is SMB1.0, however, this is always enabled and cannot be disabled.
• When a version is disabled, version settings higher than that version are all disabled. When a version is enabled, all
version settings lower than that version are enabled.
Ping Command
Checks if the machine can communicate with the PC of the network.
Specify the IP address of the desired PC and tap the [Execute] key. A message indicating a response by the PC or not
is displayed.
8-144
Advertisement
Chapters
Table of Contents
