Using Manual Finishing - Sharp MX-6580N User Manual

MANUAL FINISHING►OPERATION OF MANUAL FINISHING
OPERATION OF MANUAL FINISHING

USING MANUAL FINISHING

Change from the Home Screen or each mode to manual finishing mode, and carry out the following procedure.
SELECTING MANUAL FINISHING MODE (page 7-3)
►
1
When loading paper larger than 8-1/2" × 11"R, or A4R, extend the bypass tray all the way out. If it is not pulled all the
way out, the size of the loaded paper will not be detected correctly.
2
• Up to 200 sheets of paper can be loaded into each of the upper and lower trays.
• Insert the paper along the guides all the way into the tray.
• If the guide width is not correctly adjusted to match the paper width, paper may be jammed, skewed, or crease. Adjust
the paper guides to fit the width of the paper.
3
Output Tray
Upper Tray
Middle Tray
Lower Tray
Staple
Off
1 Staple
at Back
1 Staple Saddle
at Front Stitch
2 Staples
Inserter
Plain 1
Upper Tray
8½x11
Plain 1
Lower Tray
8½x11
Type and Size
Punch Fold
Accord-
Off Copies/Pages
Off
ion Fold
2 Hole Saddle Double
Punch Fold Fold
Half Fold Z-Fold
Start
C-Fold Detail
Set the guides to the size of the paper.
Grasp the guide lock lever to adjust the guide.
When you have finished the adjustment, release the lock
lever.
Load paper into the upper or lower
tray.
The paper orientation varies depending on the manual
finishing function.
► CHECKING TYPE AND SIZE OF PAPER (page 7-5)
► PAPER LOADING ORIENTATION (page 7-6)
Select the appropriate finishing
method.
► STAPLE FUNCTION (page 7-11)
► PUNCH FUNCTION (page 7-14)
► PAPER FOLDING FUNCTION (page 7-15)
CA
7-9