Comtech EF Data SLM-5650A Installation And Operation Manual page 234

Controller-to-Target
Instruction Code and
Qualifier
Parameter
Type
Command Query
Firmware Image IMG= IMG?
IP Address IPA= IPA?
Initialize ISP= N/A
Statistics
Pointer
LoopBack Test LOP= LOP?
Modes
Local/Remote LRS= LRS?
Status
Serial Remote Control
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
1 bytes Command or Query.
Sets or returns Next Reboot Image in the form x, where:
1 = Bulk Image #1
2 = Bulk Image #2
Example: <0001/IMG=1{CR} (Image #1 will be active after next
reboot)
18 bytes Command or Query.
Sets or returns the IP Address and Subnet Mask for the 'J5 Ethernet'
10/100 BaseT Ethernet port in the form xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx = IP Address, and
yy = Subnet Mask (0-31)
Example: <0001/IPA=010.006.030.001.24{CR}
None Command only.
Resets internal pointer to allow RNS? queries to start at the beginning
of the stored statistics log.
Note: This command takes no arguments.
1 byte Command or Query.
Sets or returns Loopback Test Modes in the form x, where:
0 = Normal Mode (no test)
1 = IF Loopback
2 = I/O Loopback #1
Exampe: <0001/LOP=1{CR} (IF Loopback)
1 byte Command or Query.
Sets or returns Local/Remote status in the form x, where:
0 = Local
1 = Serial Remote Control
3 = Serial + Ethernet Remote Control
Example: <0001/LRS=1{CR} (selects Serial Remote)
Description of Arguments
10–40
SLM-5650A Satellite Modem
Revision 10
Target-to-Controller
Response to Query
Response to
(see Description of
Command
Arguments)
IMG= IMG=x
IMG?
IMG*
IMG#
IPA= IPA=xxx.xxx.xxx.xxx.y
y
IPA?
IPA*
IPA#
ISP= N/A
ISP#
LOP= LOP=x
LOP?
LOP*
LOP#
LRS= LRS=x
LRS?
LRS*
LRS#
MN-SLM-5650A