Admin | Remote; Figure 9-5. Admin | Remote Page - Comtech EF Data SLM-5650A Installation And Operation Manual

9.3.2.2

Admin | Remote

Chapter 8. ETHERNET INTERFACE OPERATION, Section 8.2 SNMP
Interface.
The Administrator must use this page to manage the SNMP settings.
Click [Submit] to save any changes made on this page. Click [Reboot Now!] to ensure any
changes associated with SNMP Version 3 take effect.
After you select SNMPv3 and reboot the modem, the HTTP and
Telnet access will be blocked. This operational change also
forces the Trap mode to be SNMPv3Traps.
The SNMPv3 mode uses the Base Modem's IP Address via the 'J5
Ethernet' port. The Base Modem HTTPS Interface is accessible by
the NP IP Address or the TRANSEC IP Address.
If you are running Base Firmware Version 1.4.8c or higher, you
must make sure to only use SNMP Trap Port values that are not
already in use by other services.
Base Modem HTTP Interface Operation

Figure 9-5. Admin | Remote Page

9–10
SLM-5650A Satellite Modem
Revision 10
MN-SLM-5650A