Comtech EF Data SLM-5650A Installation And Operation Manual page 254

Controller-to-Target
Instruction Code and
Qualifier
Parameter
Type
Command Query
Rx Ternary RTC= RTC?
Code
Receive T1 T1F= T1F?
Framing
Receive T2 T2F= T2F?
Framing
Tx Ternary TTC= TTC?
Code
Serial Remote Control
Arguments
for Command
(Note that all arguments are ASCII numeric codes from 48 to 57)
or Query
1 byte Command or Query.
Sets or returns Rx Ternary Code in the form x, where:
0 = AMI
1 = B8ZS
2 = B6ZS
3 = HDB3
Example: <0001/RTC=3{CR} (Sets Rx Ternary Code to HDB3)
1 byte Command or Query.
Sets or returns Receive T1 Framing in the form x, where:
0 = None
1 = G.704
Note: Command and Queries are not allowed when either the GBEI
or NP Module has been selected as the current interface type.
Example: <0001/T1F=0{CR}
1 byte Command or Query.
Sets or returns Receive T2 Framing in the form x, where:
0 = None
1 = G.704
3 = G.743
5 = G.747
Note: Command and Queries are not allowed when either the GBEI
or NP Module has been selected as the current interface type.
Example: <0001/T2F=0{CR}
1 byte Command or Query.
Sets or returns Tx Ternary Code in the form x, where:
0 = AMI
1 = B8ZS
2 = B6ZS
3 = HDB3
Example: <0001/TTC=3 (Sets Tx Ternary Code to HDB3)
Description of Arguments
10–60
SLM-5650A Satellite Modem
Revision 10
Target-to-Controller
Response to Query
Response to
(see Description of
Command
Arguments)
RTC= RTC=x
RTC?
RTC*
RTC#
T1F= T1F=x
T1F?
T1F*
T1F#
T2F= T2F=x
T2F?
T2F*
T2F#
TTC= TTC=x
TTC?
TTC*
TTC#
MN-SLM-5650A