Setting A Frequency; Selecting A Tuning Step - Icom ID-31E PLUS Basic Manual

3
BASIC OPERATION
■ Setting a noequency
D Selecting a tuning step
When you select the operating frequency by rotating [DIAL]
in the VFO mode, the frequency changes in the selected
tuning step.
1. Push [QUICK].
2. Rotate [DIAL] to select "TS."
3. Select a tuning step.
Optifns (kHz):
5.0 6.25
25.0 30.0
• Sets the tuning step, then returns to the standby screen.
L You can set the tuning step for both the VFO and Memory
mode.
L The VFO mode scan and the Band Scope function also use
this step to search for a signal.
15
BASIC MANUAL
10.0 12.5 15.0 20.0
50.0 100.0 125.0 200.0
D Selecting the 1 MHz tuning
You can change the operating frequency in 'MHz' steps for
quick tuning.
1. In the VFO mode, push [V/MHz].
• Enters the 1 MHz Tuning Select mode.
• The 1 MHz digit blinks.
Blinks
2. Rotate [DIAL].
• The frequency changes in 1 MHz steps.
Blinks
3. Push [ENT].
• Sets the frequency, then returns to the standby screen.
L The tuning step setting (to the left) remains.