Table of Contents
Advertisement
D-STAR OPERATION
■ Making a Gateway CQ call
You can make a Gateway CQ call when a destination
repeater is selected in "TO" (Destination).
What is a Gateway CQ call?
• To call a CQ through a repeater connected to the
Internet.
• You can call a CQ to the areas where you cannot directly
access because the communication is routed through
the Internet.
Step 1: Set "FROM" (Access repeater).
L Same as described in page 48.
Step 2: Set "TO" (Destination).
1.
Push [RX→CS] to select "TO," then push [ENT].
2. Select "Gateway CQ."
49
D-STAR GUIDE
[Up]
[ENT]
[Down]
3. Select the repeater group where your destination
repeater is listed.
4.
Select your destination repeater.
• Returns to the DR screen, and the selected repeater name is
displayed in "TO."
Step 3: Hold down [PTT] to transmit.
• The TX/RX indicator lights red while transmitting.
NOTE: If the selected Access repeater does not connect
to the gateway, "
"is displayed. In that case, you
cannot select "Gateway CQ."
(
Example: "Japan")
( Example: The destination
repeater is set to "Inage.")
Advertisement
Table of Contents
