Requesting Repeater Information - Icom ID-31E PLUS Basic Manual

D Reflector Echo Testing
To confirm that your signal is correctly getting into the
repeater, you can transmit a short message as a trial.
After releasing [PTT], your message will be played back.
1. Push [RX→CS] to select "TO," then push [ENT].
• Displays the TO SELECT screen.
2. Select "Reflector."
• Displays the REFLECTOR screen.
3. Select "Echo Test."
• Returns to the DR screen, and "Echo Test" and "E" are
displayed in "TO."
4. Hold down [PTT] and speak into the microphone.
• The TX/RX indicator lights red while transmitting.
5. Release [PTT] to hear your message.
D Requesting repeater information
When you send the repeater information command, an ID
message is sent back.
1.
2. Select "Reflector."
[Up]
3. Select "Repeater Information."
[ENT]
[Down]
4.
5. Release [PTT] to hear the repeater ID message.
Push [RX→CS] to select "TO," then push [ENT].
• Displays the TO SELECT screen.
• Displays the REFLECTOR screen.
• Returns to the DR screen, and "Repeater Information" and "I"
are displayed in "TO."
Hold down [PTT] to transmit the repeater information
command.
• The TX/RX indicator lights red while transmitting.
D-STAR OPERATION
[Up]
[ENT]
[Down]
D-STAR GUIDE
56