Table of Contents
Advertisement
Step 2: Set "TO" (Destination).
1.
Push [RX→CS] to select "TO" then push [ENT].
2. Select "Gateway CQ."
3. Select the repeater group where your destination
repeater is listed.
4.
Select your destination repeater.
[Up]
[ENT]
[Down]
(
Example: "Australia")
• Returns to the DR screen, and the selected repeater name is
displayed in "TO."
Step 3: Check whether you can access the repeater.
Hold down [PTT] for 1 second to access the repeater.
L If you get a reply call, or "UR?" is displayed within 3
seconds, your signal reached your access repeater and
your call was successfully sent from your destination
repeater.
Successfully sent!
TIP: See page 62 for status indications after a reply is
received.
D-STAR OPERATION
(
Example: "Melbourne")
D-STAR GUIDE
44
Advertisement
Table of Contents
