D-STAR OPERATION
■ Accessing repeaters
This section describes how to check whether or not you can
access your local area repeater (access repeater), and your
signal is successfully sent to a destination repeater.
TIP: If your call sign (MY) has not been set, or your call
sign and D-STAR equipment have not been registered at
a D-STAR repeater, see pages 39 ~ 42.
Step 1: Set "FROM" (Access repeater).
1.
Push [DR] to select "FROM" then push [ENT].
2. Select "Repeater List."
3. Select the repeater group where your access repeater
is listed.
43
D-STAR GUIDE
[Up]
[ENT]
[Down]
(
Example: "USA West")
4.
Select your access repeater.
• Returns to the DR screen, and the selected repeater name is
displayed in "FROM."
L By just selecting the repeater name, the repeater call sign,
its frequency, duplex setting, and frequency offset are
automatically set.
L A repeater list here is just an example.
TIP: There are several ways to set your access repeater.
(p. 60)
• Setting by [DIAL]
• Searching for a repeater using the DR scan
• Searching for the nearest repeater
• Setting from the TX History
(
Example: "Kirkland (IA)")