Icom ID-31E PLUS Basic Manual page 76

D-STAR OPERATION
PROBLEM
After your call, the repeater
replies 'RPT?' and the destination
repeater's call sign.
Even holding down [DR], the DR
screen is not displayed.
Even holding down [RX→CS], the
received call sign will not set to the
destination call sign.
A Local area call can be made,
but the Gateway call or destination
station call cannot be made.
"L" is displayed on the LCD.
"DV" and "FM" icons alternately
blink.
* "AM" indicates the PDF type ADVANCED MANUAL.
63
D-STAR GUIDE
POSSIBLE CAUSE
• The repeater cannot connect to the
destination repeater.
• The repeater is busy.
• There is no repeater list in your transceiver.
• The Lock function is activated.
• The call sign has not been correctly
received.
• When a received signal is weak, or a signal
is received during scanning, the call sign
may not be received correctly. In that case,
"--------" is displayed and error beeps sound,
and a reply call cannot be made.
• MY call sign has not been registered on a
D-STAR repeater.
• The repeater set in "FROM" (Access
Repeater) has no Gateway.
While receiving through the internet, some
packets may be lost due to network error
(poor data throughput performance).
While in the DV mode, an FM signal is
received.
SOLUTION
• Check the repeater settings.
• Wait for a while, and try it again.
• Import the repeater using a microSD card.
• Directly enter the Repeater list data into the
transceiver.
• Hold down [ ] for 1 second to turn OFF the
Lock function.
Try it again, after the transceiver has correctly
received the call sign.
• Register your own call sign (MY) on a gateway
repeater, or confirm the registration of the call
sign.
• Check the repeater settings.
Wait a while, and try it again.
L When the transceiver receives corrupted
data, and misidentifies it is as Packet Loss,
"L" is displayed, even if it is a Local area call.
Use a different operating frequency until there
are no FM signals on the original frequency.
REF.
—
p. 57
AM*
Sec. 4
—
—
p. 41
—
AM*
Sec. 4