Table of Contents
Advertisement
D-STAR OPERATION
■ Making a Simplex call
This section describes the simplex operation (through no
repeater).
NOTE: Depending on the transceiver's version,
the frequencies may be different. Check for usable
frequencies for your operating area.
What is a Simplex Call?
A simplex call is a direct call to another station on a single
frequency, not using a repeater.
D In the VFO mode
1.
Push [V/MHz] to enter the VFO mode.
2. Push [FM/DV] to set the operating mode to DV.
3. Rotate [DIAL] to set the operating frequency. (p. 15)
4.
Hold down [LOW] for 1 second to set an output power.
51
D-STAR GUIDE
Information
L
• You can select S-LOW, LOW 1, LOW 2, MID, or HIGH each
time you hold down [LOW] for 1 second.
• You can also select an output power by rotating [DIAL] while
holding down [LOW].
• When you select a high power, the power icon disappears.
• Select a level to suit your operating requirements.
5. Hold down [PTT] to transmit, and speak into the
microphone at your normal voice level.
• The TX/RX indicator lights red.
• The S/RF meter displays the output power level.
6. Release [PTT] to receive.
TIP: If you enter a DV simplex frequency to a Memory
channel, you can also make a simplex call in the Memory
mode. See page 21 on how to enter Memory channels.
Advertisement
Table of Contents
