Replacing The Operator Information Panel Assembly - Lenovo System x3550 M4 Installation And Service Manual

Figure 210. Operator information panel removal
Step 6. From the front of the server, carefully pull the assembly out of the server while you move it slightly
from side to side.
If you are instructed to return the operator information panel assembly, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.

Replacing the operator information panel assembly

Use this information to replace the operator information panel assembly.
To install the operator information panel, complete the following steps.
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page
31.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the cover (see "Removing the cover" on page 194).
Step 4. From the front of the server, slide the operator information panel into the server until it clicks into
place.
Figure 211. Operator information panel installation
Step 5. Inside the server, connect the cable to the rear of the operator information panel assembly.The
following illustration shows the cable routing for the operator information panel.
282
Lenovo System x3550 M4 Installation and Service Guide