Lenovo System x3550 M4 Installation And Service Manual page 77

Note: Changes are made periodically to the website. The actual procedure might vary slightly from what
is described in this document.
• Port 0 on the Emulex Dual Port 10GbE SFP+ Embedded VFA III can be configured as shared system
management.
• When the server is in standby mode, both ports on the Emulex Dual Port 10GbE SFP+ Embedded VFA III
function at 100M connection speed with Wake on LAN feature.
The Emulex Dual Port 10GbE SFP+ Embedded VFA III is automatically disabled if one of the following errors
occurs:
• An error log indicates a temperature warning for the Ethernet adapter.
• All power supplies are removed or the server is disconnected from the power source.
To install the dual-port network adapter, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page
31.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the cover (see "Removing the cover" on page 34).
Step 4. Remove the PCI riser-card assembly (if installed) from PCI riser connector 2 (see "Removing a PCI
riser-card assembly" on page 223).
Step 5. Remove the adapter filler panel on the rear of the chassis (if it has not been removed already).
Figure 50. Adapter filler panel removal
Step 6. Touch the static-protective package that contains the new adapter to any unpainted metal surface
on the server. Then, remove the adapter from the package.
Step 7. Align the adapter so that the port connectors on the adapter line up with the pin and thumbscrew
on the chassis; then, align the connector of the adapter with the adapter connector on the system
board.
.
Chapter 2 Installing optional devices
63