Lenovo System x3550 M4 Installation And Service Manual page 221

• Select the bay in which you want to install the drive.
• Check the instructions that come with the drive to determine whether you have to set any switches or
jumpers on the drive. If you are installing a SATA device, be sure to set the SATA ID for that device.
• You can install up to three 3.5-inch simple-swap SATA hard disk drives in the server. Do not install hot-
swap drives into a simple-swap server model, it is not supported.
• You can install one 2.5-inch simple-swap SATA hard disk drives in bay 0 in the server. Do not install hot-
swap drives into a simple-swap server model, it is not supported.
• The simple-swap server models are available only in non-RAID configurations.
• The electromagnetic interference (EMI) integrity and cooling of the server are protected by having all bays
and PCI and PCI Express slots covered or occupied. When you install a drive, PCI, or PCI Express
adapter, save the EMC shield and filler panel from the bay or PCI or PCI Express adapter slot cover in the
event that you later remove the device.
To install a simple-swap hard disk drive, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page
31.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables.
Step 3. Remove the filler panel from the empty drive bay.
Step 4. Touch the static-protective package that contains the drive to any unpainted metal surface on the
server; then, remove the drive from the package and place it on a static-protective surface.
Step 5. Install the hard disk drive in the drive bay:
a. Grasp the black drive handle and slide the blue release latch to the right and align the drive
assembly with the guide rails in the bay.
Figure 121. 2.5-inch simple-swap hard disk drive installation
Figure 122. 3.5-inch simple-swap hard disk drive installation
.
Chapter 6 Removing and replacing components
207