Figure 184. Backplate assembly installation
b.
Adjust the latch to the locked position on 3.5-inch server models.
Figure 185. Latch adjustment
Step 4.
Connect the signal and power cables to the system board. Route the signal cable from the drive
backplane along the chassis and connect it to the SAS/SATA signal connector. Then, route the
power cable from the drive backplate assembly along the chassis and connect it to the simple-
swap SATA power connector. See "Cabling backplane" on page 187 for more information.
Step 5.
Reinstall the hard disk drives and filler panels (see "Replacing simple-swap hard disk drives" on
page 206).
266
Lenovo System x3550 M4 Installation and Service Guide