Replacing The Cover - Lenovo System x3550 M4 Installation And Service Manual

Figure 79. Air baffle installation

Replacing the cover

Use this information to replace the cover.
To replace the server cover, complete the following steps:
Step 1. Make sure that all cables, adapters, and other components are installed and seated correctly and
that you have not left loose tools or parts inside the server. Also, make sure that all internal cables
are correctly routed.
Important: Before you slide the cover forward, make sure that all the tabs on the front, rear, and
side of the cover engage the chassis correctly. If all the tabs do not engage the chassis correctly, it
will be very difficult to remove the cover later.
Step 2. Position the cover on top of the server.
Step 3. Slide the cover toward the front of the server.
Step 4. Make sure that the cover correctly engages all the inset tabs on the server.
Step 5. Press down the blue latch on the top (in the center of the front of the server) of the cover.
.
Chapter 2 Installing optional devices
87