Figure 195. Bezel installation
Step 5.
Rotate the bezel upward to the server and reinstall the screws.
Note: Use the T8 Torx screwdriver that comes with the new bezel to install the bezel.
Figure 196. T8 Torx screwdriver
Figure 197. Bezel screws installation
Step 6.
Reinstall the hard disk drives and drive bay filler panels into the drive bays (see "Replacing hot-
swap hard disk drives" on page 203 or "Replacing simple-swap hard disk drives" on page 206).
Step 7.
Install the cover (see "Replacing the cover" on page 195).
Step 8.
Reconnect the power cords and any cables that you removed.
Step 9.
Slide the server into the rack.
Step 10. Turn on the peripheral devices and the server.
274
Lenovo System x3550 M4 Installation and Service Guide