YASKAWA SGD7S Product Manual page 496

15.1 List of Parameters
15.1.2 List of Parameters
Parameter
No.
Pn00A
Pn00B
15-8
Name
Application Function
2
Selections A
Motor Stopping Method for Group 2 Alarms
Apply the dynamic brake or coast the motor to a stop (use the
0
stopping method set in Pn001 = n.X).
Decelerate the motor to a stop using the torque set in Pn406 as
1 the maximum torque. Use the setting of Pn001 = n.X for the
status after stopping.

n. X
Decelerate the motor to a stop using the torque set in Pn406 as
2
the maximum torque and then let the motor coast.
Decelerate the motor to a stop using the deceleration time set in
3 Pn30A. Use the setting of Pn001 = n.X for the status after
stopping.
Decelerate the motor to a stop using the deceleration time set in
4
Pn30A and then let the motor coast.
 
n. X Reserved parameter (Do not change.)
 
n. X Reserved parameter (Do not change.)

n.X Reserved parameter (Do not change.)
Application Function
2
Selections B
Operator Parameter Display Selection

n. X 0 Display only setup parameters.
1 Display all parameters.
Motor Stopping Method for Group 2 Alarms
0 Stop the motor by setting the speed reference to 0.
 
n. X
Apply the dynamic brake or coast the motor to a stop (use the
1
stopping method set in Pn001 = n.X).
2 Set the stopping method with Pn00A = n.X.
Power Input Selection for Three-phase SERVOPACK
0 Use a three-phase power supply input.
 
n. X
Use a three-phase power supply input and as a single-phase
1
power supply input.

n.X Reserved parameter (Do not change.)
Setting Setting Default
Range Unit Setting
0000 hex to 0001
−
0044 hex hex
0000 hex to 0000
−
1121 hex hex
Continued from previous page.
Applicable When Classi-
Motors Enabled fication
After
All Setup
restart
Reference
page 5-36
After
All Setup
restart
Reference
page 5-3
Reference
page 5-36
Reference
page 5-14
Continued on next page.
Refer-
ence
−
−