Ipv6 Interface Settings - D-Link xStack DGS-3400 Series Reference Manual
Web ui reference guide for layer 2+ managed gigabit ethernet switch
Hide thumbs
Also See for xStack DGS-3400 Series:
- Reference manual (629 pages) ,
- Cli reference manual (540 pages) ,
- Cli manual (463 pages)
Table of Contents
Advertisement
x Stack
IPv6 Interface Settings
This window is used to set up IPv6 interfaces and addresses for the Switch.
To view this window, click Administration > Interface Settings > IPv6 Interface Settings, as shown below.
To add a new IPv6 interface, click the Add button, which will display the following window.
To add an Interface, enter an Interface Name in the field provided, along with a corresponding VLAN Name, set the Interface
Admin. State to Enabled and click Apply. Newly created interfaces will appear in the IPv6 Interface Settings window.
To change the settings for a configured Interface, click the corresponding Modify button, which will display the following
window for the user to configure.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
NOTE: The Switch's factory default IP address is 10.90.90.90 with a
subnet mask of 255.0.0.0 and a default gateway of 0.0.0.0.
Figure 2 - 6 IPv6 Interface Settings window
Figure 2 - 7 IPv6 Interface Settings - Add window
19
Advertisement
Table of Contents
