Dns Resolver Dynamic Name Server Table; Dns Resolver Static Host Name Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack
Click Add to reveal the following window to configure:
Figure 2 - 113 DNS Resolver Static Name Server Settings window
The following fields can be set:
Parameter
Primary
IP Address
Click Apply to implement changes made.

DNS Resolver Dynamic Name Server Table

This read-only window is used to display the DNS resolver dynamic name server table.
To view this window, click Administration > DNS Resolver > DNS Resolver Dynamic Name Server Table, as shown below.
Figure 2 - 114 DNS Resolver Dynamic Name Server Table window

DNS Resolver Static Host Name Settings

This window is used to create or delete a static host name entry of the Switch. If the created host name entry exists in the dynamic
host name table, the existing dynamic host name entry will be deleted, and the created host name entry is then added into the static
host name table and a log for a duplicate is recorded.
To view this window, click Administration > DNS Resolver > DNS Resolver Static Host Name Settings, as shown below.
To remove an entry from the table, click its corresponding
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Description
Tick the check box to indicate the name server is a primary name server.
Enter the DNS resolver name server IP address.
Figure 2 - 115 DNS Resolver Static Host Name Table window
under the Delete heading.
102