D-Link xStack DGS-3400 Series Reference Manual page 281

x Stack
Figure 5 - 18 Access Rule Configuration window (Packet Content)
To set the Access Rule for the Packet Content Mask, adjust the following parameters and click Apply.
Parameter
Profile ID
Mode
Access ID (1-128)
Type
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a port
defined in the Port Mirroring window. Port Mirroring must be enabled and a target port must be
set.
Type in a unique identifier number for this access. This value can be set from 1 to 128.
•
Auto Assign – Ticking this check box will instruct the Switch to automatically
assign an Access ID for the rule being created.
Specifies the type of profile that is being created.
268