Trap Source Interface Settings; Poe - D-Link xStack DGS-3400 Series Reference Manual

x Stack
To change the Engine ID, enter the new Engine ID in the space provided and click the Apply button.

Trap Source Interface Settings

This window is used to configure the trap source interface settings.
To view this window, click Administration > Trap Source Interface Settings, as shown below.
The following parameters can be configured:
Parameter
Interface Name
IPv4 Address
IPv6 Address
Click Apply to implement the changes. To remove an entry, click the corresponding

PoE

The DGS-3426P switch supports Power over Ethernet (PoE) as defined by the IEEE 802.3af. Ports 1-24 can supply about 48 VDC
power to Powered Devices (PDs) over Category 5 or Category 5E UTP Ethernet cables. The DGS-3426P follows the standard
PSE (Power Sourcing Equipment) pinout Alternative A, whereby power is sent out over pins 1, 2, 3 and 6. The DGS-3426P works
with all D-Link 802.3af capable devices.
The DGS-3426P includes the following PoE features:
Auto-discovery recognizes the connection of a PD (Powered Device) and automatically sends power to it.
The Auto-disable feature occurs under two conditions: first, if the total power consumption exceeds the system power limit; and
second, if the per port power consumption exceeds the per port power limit.
Active circuit protection automatically disables the port if there is a short. Other ports will remain active.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 131 SNMP Engine ID window
Figure 2 - 132 Trap Source Interface Settings window
Description
Enter a name of the interface.
Tick the check box and enter an IPv4 address.
Tick the check box and enter an IPv6 address.
114
button.