Ripng - D-Link xStack DGS-3400 Series Reference Manual

x Stack
The following RIP interface settings can be applied to each IP interface:
Parameter Description
Interface Name
The name of the IP interface on which RIP is to be setup. This interface must be previously
configured on the Switch.
IP Address The IP address corresponding to the Interface Name showing in the field above.
TX Mode Toggle among Disabled, V1 Only, V1 Compatible, and V2 Only. This entry specifies which
version of the RIP protocol will be used to transmit RIP packets. Disabled prevents the
transmission of RIP packets.
RX Mode Toggle among Disabled, V1 Only, V2 Only, and V1 or V2. This entry specifies which version of
the RIP protocol will be used to interpret received RIP packets. Disabled prevents the reception
of RIP packets.
Authentication Toggle between Disabled and Enabled to specify that routers on the network should us the
Password above to authenticate router table exchanges.
Password A password to be used to authenticate communication between routers on the network.
State Toggle between Disabled and Enabled to disable or enable this RIP interface on the switch.
Interface Metric
A read only field that denotes the Metric value of the current IP Interface setting.
Click Apply to implement the changes. To return to the RIP Interface Settings window, click the
link.

RIPng

The Switch supports Routing Information Protocol next generation (RIPng). RIPng is a routing protocol that exchanges routing
information used to compute routes and is intended for IPv6-based networks.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 170 RIP Interface Settings - Edit window
146
Show All RIP Interface Entries