D-Link xStack DGS-3400 Series Reference Manual page 141

x Stack
Figure 2 - 148 IP Multicast VLAN Replication Settings - Source Edit window
The following fields may be set:
Parameter
Entry Name
VID / VLAN Name
Action
Multicast IP
Address List
Source IP Address
Click Apply to implement the changes. To return to the IP Multicast VLAN Replication Settings window, click the
Multicast VLAN Replication Entries
The following table is used to set the Destination settings, to view this window click the corresponding View button in the IP
Multicast VLAN Replication Entries table as shown below.
This table is used to configure the destination, so when traffic matches an IP Multicast VLAN Replication entry, it will be
replicated based on the destination settings. Multiple destination entries can be defined and each destination entry specifies the
VLAN and the outgoing port on which the traffic will be replicated. The outgoing port must be a member port of the VLAN,
whether the egress packet is tagged or untagged based on the VLAN settings.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Description
The name of the previously created IP Multicast VLAN Replication entry will be displayed.
Select VID and enter a source VLAN ID. Select VLAN Name and enter a source VLAN Name.
When Group is selected, the user can configure the Action, Multicast IP Address List and the
Source IP Address in the following fields.
The user can specify to either Add or Delete the IP multicast address.
A multicast IP address list can be entered.
A source IP Address can be specified.
link.
128
Show All IP