Wac Global Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack
6. If a RADIUS server is to be used for authentication, the user must first establish a RADIUS Server with the appropriate
parameters, including the target VLAN, before enabling the Web-based Access Control on the Switch.

WAC Global Settings

This window is used to enable and configure Web-based Access Control Global State on the Switch.
To view this window, click Security > Web-based Access control (WAC) > WAC Global Settings, as shown below.
The following parameters can be configured:
Parameter
WAC Global State
Method
Redirection Path
Virtual IP
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 6 - 33 WAC Global State window
Description
Use this drop-down menu to either enable or disable WAC on the Switch.
Use the drop-down menu to configure the Method, choose between Local or RADIUS.
Local – Specifies that authentication will be done via the local database.
RADIUS – Specifies that authentication will be done via the RADIUS server.
Enter a redirection path that the client will be redirected to after successful authentication.
When the string is cleared, the client will not be redirected to another URL after successful
authentication.
Enter a virtual IPv4 address so that the TCP packets sent to the virtual IP will get a reply. If
the virtual IP is enabled, the TCP packets sent to the virtual IP or physical IPIF's (IP
Interface's) IP address will both get a reply. When the virtual IP is set to 0.0.0.0 the
function will be disabled. To ensure that this function works correctly, the virtual IP address
must not be configured to be an IP address that exists on the subnet.
WAC Settings
323