Password Encryption; Mirror; Port Mirror Global Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack
User Name
Enter a name for the account, or display the name of the selected account.
Old Password Enter the original password of the existing account.
New Password Enter a new password for the account.
Confirm new
Retype the new password to confirm.
Password
Access Right
Use the pull-down menu to select the access right of the account or display the access right of
the selected account.
Encrypt Tick the check box and select the type of encryption (Plain Text or SHA_1) from the pull-down
menu.
Encrypt Enter the password for the type of encryption.
Password
Click the Show All User Account Entries
Click Delete in the User Account Modify Table window to remove the selected user account.

Password Encryption

Password encryption allows the user to encrypt a password for additional security.
To view this window, click Administration > Password Encryption, as shown below.
The following parameters can be configured:
Parameter Description
Encryption State Use the pull-down menu to enable or disable the password encryption. Select Enabled to
change the password into encrypted form. When password encryption is Disabled, the
password will be in plain text form. However, if the user specifies the password in encrypted
form, or if the password has been converted to encrypted form by the last enable password
encryption command, the password will still be in encrypted form and cannot be reverted back
to plaintext form.
Click Apply to implement the changes.

Mirror

This section contains information for mirroring port configurations, including Port Mirror Global Settings and Port Mirror
Settings.

Port Mirror Global Settings

This window is used to configure the port mirror status without having to modify the settings in Port Mirror Settings window.
To view this window, click Administration > Mirror > Port Mirror Global Settings, as shown below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
link to return to the User Accounts window. Click Apply to implement the changes.
Figure 2 - 31 Password Encryption window
41