Wac User Account - D-Link xStack DGS-3400 Series Reference Manual

x Stack
Block Time (0-300
sec)
Click Apply to implement the changes.

WAC User Account

This window is used to enable and configure Web-based Access Control User Account Settings on the Switch.
To view this window, click Security > Web-based Access control (WAC) > WAC User Account, as shown below.
To create a new user account click Add, the following window will be displayed for the user to configure.
To edit an entry click the corresponding Modify button, as shown below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
value between 1 and 1440 minutes. A value of Infinite indicates the Idle state of the
authenticated host on the port will never be checked. The default setting is Infinite.
This parameter specifies the period of time a host will keep in a blocked state after it fails
to authenticate. Enter a value between 0 and 300 seconds. The default setting is 60
seconds.
Figure 6 - 35 WAC User Account window
Figure 6 - 36 WAC User Account - Add window
326