Vlan Status Port; Port Access Control; Authenticator State - D-Link xStack DGS-3400 Series Reference Manual

x Stack

VLAN Status Port

This window allows the VLAN status for each of the Switch's ports to be viewed. To view settings for a particular port, enter the
port number and click Find.
To view this window, click Monitoring > VLAN Status Port, as shown below.

Port Access Control

The following screens are used to monitor 802.1X statistics of the Switch, on a per port basis. To view the Port Access Control
windows, open the monitoring folder and click the Port Access Control folder. There are six windows to monitor.

Authenticator State

The following section describes the 802.1X Authenticator State on the Switch. This window displays the Authenticator State for
individual ports on a selected device. In Port-based mode if one of the attached hosts is successfully authorized, all hosts on the
same port will be granted access to the network. If the port authorization fails, the specified port(s) will continue authenticating. In
Host-based mode each user can individually authenticate and access the network.
To view this window, click Monitoring > Port Access Control > Authenticator State, as shown below.
The user may also view this window if any port/host is authenticated.
Parameter
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 7 - 23 VLAN Status Port window
NOTE: The Authenticator State cannot be viewed on the Switch unless
802.1X is enabled by port or by MAC address. To enable 802.1X, go to
the DGS-3400 Web Management Tool window.
Figure 7 - 24 Authenticator State window
Description
393