Ipv6 Neighbor; Ipv6 Neighbor Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack

IPv6 Neighbor

IPv6 neighbors are devices on the link-local network that have been detected as being IPv6 devices. These devices can forward
packets and keep track of the reachability of routers, as well as if changes occur within link-layer addresses of nodes on the
network or if identical unicast addresses are present on the local link. The following two windows are used to view IPv6
neighbors, and add or delete them from the Neighbor cache.

IPv6 Neighbor Settings

The following window is used to view, configure and delete current IPv6 neighbors of the Switch.
To view this window, click Administration > IPv6 Neighbor > IPv6 Neighbor Settings, as shown below.
The following fields can be configured or viewed:
Parameter
Interface Name
Neighbor IPv6
Address
State
Neighbor IPv6
Address
State
Link Layer MAC
Address
Port
Interface
VID
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 54 IPv6 Neighbor Settings window
Description
Enter the interface name of the IPv6 neighbor you wish to find.
Enter the neighbor IPv6 address of the entry you wish to find.
To find specific entries, tick the check box and select either Static or Dynamic.
Static – Select Static to view all statically entered IPv6 neighbors on the Switch.
Dynamic – Select Dynamic to view all dynamically configured neighbor devices which are IPv6
neighbors of the IP interface previously created.
Display the IPv6 address of the neighbor device.
Display the running state of the corresponding IPv6 neighbor. The user may see six possible
entries in this field, which are Incomplete, Stale, Probe, Reachable, Delay or Static.
Display the MAC address of the corresponding IPv6 device.
Display the port for IPv6 neighbor settings.
Display the Interface name associated with this IPv6 address.
Display which VLAN learned the IPv6 address of the neighbor device.
IPv6 Neighbor Settings
61