Table of Contents
Advertisement
fields. Pull the Interface Admin State drop-down menu to Enabled and click Apply to enter to make the IP interface effective. To
view entries in the IP Interface Settings, click the
from the Save Services folder to enter the changes into NV-RAM.
The following fields can be set or modified:
Parameter
Interface Name
IP Address
Subnet Mask
VLAN Name
Interface Admin. State
Click Apply to implement changes made.
IPv6 Interface Settings
This window is used to set up IPv6 interfaces and addresses for the Switch.
To view this window, click Administration > Interface Settings > IPv6 Interface Settings, as shown below:
To add a new IPv6 interface, click the Add button, which will display the following window.
To add an Interface, enter an Interface Name in the field provided, along with a corresponding VLAN Name, set the Interface
Admin. State to Enabled and click Apply. Newly created interfaces will appear in the IPv6 Interface Settings window.
To change the settings for a configured Interface, click the corresponding Modify button, which will display the following
window for the user to configure.
®
xStack
DGS-3426G Layer 2 Gigabit Ethernet Managed Switch
Description
This field displays the name for the IP interface or it is used to add a new interface created
by the user. The default IP interface is named "System".
This field allows the entry of an IPv4 address to be assigned to this IP interface.
This field allows the entry of a subnet mask to be applied to this IP interface.
This field displays the VLAN name directly associated with this interface.
Use the drop-down menu to enable or disable configuration on this interface.
NOTE: The Switch's factory default IP address is 10.90.90.90 with a
subnet mask of 255.0.0.0 and a default gateway of 0.0.0.0.
Figure 2 - 6 IPv6 Interface Settings window
Figure 2 - 7 IPv6 Interface Settings – Add
Show All IP Interface Entries
18
hyperlink. Use the Save Changes dialog box
Advertisement
Table of Contents
