D-Link xStack DGS-3400 Series Reference Manual page 136

x Stack
To view this window, click Administration > sFlow > sFlow Sampler Settings, as shown below.
The following fields are displayed:
Parameter
Port
Analyzer Server ID
Configured RX/TX
Rate
Active RX/TX Rate
Max Header Size
To remove an entry, click the corresponding
To add a new sFlow Sampler entry, click the Add button which will display the following window to be configured:
To change an sFlow Sampler, click the corresponding Modify button in the sFlow Sampler Settings window that will display the
following window to be configured:
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 140 sFlow Sampler Settings window
Description
Displays the port from which packet samples are being extracted.
Displays the ID of the Analyzer Server where datagrams, containing the packet sampling
information taken using this sampling mechanism, will be sent.
Displays the configured rate of packet sampling for this port based on a multiple of 256. For
example, if a figure of 20 is in this field, the switch will sample one out of every 5120 packets
(20 x 256 = 5120) that pass through the individual port.
Displays the current rate op packet sampling being performed by the Switch for this port,
based on a multiple of 256. For example, if a figure of 20 is in this field, the switch will sample
one out of every 5120 packets (20 x 256 = 5120) that pass through the individual port.
Displays the number of leading bytes of the sampled packet header. This sampled header will
be encapsulated with the datagram to be forwarded to the Analyzer Server.
button. Click the Clear All button to delete all entries.
Figure 2 - 141 sFlow Sampler Settings - Add window
123