Dhcp Server Exclude Address Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack
The following parameters may be configured:
Parameter
DHCP Server Global
State
Ping Packets (Number
2-10)
Ping Timeout
(Millisecond 500-2000)
Click Apply to implement the changes.

DHCP Server Exclude Address Settings

The following window will allow the user to set an IP address, or a range of IP addresses that are NOT to be included in the range
of IP addresses that the Switch will allot to clients requesting DHCP service. To set an IP address or range of IP addresses, enter
the Begin Address of the range and then the End Address of the range and click Apply. Set address ranges will appear in the
DHCP Exclude Address Table in the bottom half of the window, as shown below.
To view this window, click Administration > DHCP Server > DHCP Server Exclude Address Settings, as shown below.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 82 DHCP Server Settings window
Description
Use the pull-down menu to globally enable or disable the switch as a DHCP server.
Enter a number between 2 and 10 to denote the number of ping packets that the Switch
will send out on the network containing the IP address to be allotted. If the ping request is
not returned, the IP address is considered unique to the local network and then allotted to
the requesting client. The default setting is 2 packets.
The user may set a time between 500 and 2000 milliseconds that the Switch will wait
before timing out a ping packet. The default setting is 500 milliseconds.
80