D-Link xStack DGS-3400 Series Reference Manual page 273

x Stack
The following parameters can be set, for IP:
Parameter
Profile ID (1-6)
Type
Class
Flow Label
Source IPv6 Mask
Destination IPv6
Mask
Protocol
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 5 - 9 Access Profile Configuration window (IPv6)
Description
Type in a unique identifier number for this profile set. This value can be set from 1 to 6.
Select profile based on Ethernet (MAC Address), IP, Packet Content or IPv6 address. This
will change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet header.
Select IP to instruct the Switch to examine the IP address in each frame's header.
Select IPv6 to instruct the Switch to examine the IPv6 address in each frame's header.
Select Packet Content to instruct the Switch to examine the packet header.
Checking this field will instruct the Switch to examine the class field of the IPv6 header. This
class field is a part of the packet header that is similar to the Type of Service (ToS) or
Precedence bits field in IPv4.
Checking this field will instruct the Switch to examine the flow label field of the IPv6 header.
This flow label field is used by a source to label sequences of packets such as non-default
quality of service or real time service packets.
The user may specify an IP address mask for the source IPv6 address by checking the
corresponding box and entering the IP address mask.
The user may specify an IP address mask for the destination IPv6 address by checking the
corresponding box and entering the IP address mask.
Selecting this option instructs the Switch to examine the protocol type value in each frame's
header. Then the user must specify what protocol(s) to include according to the following
guidelines:
Select TCP to use the TCP port number contained in an incoming packet as the forwarding
criterion. Selecting TCP requires that you specify a source port mask and/or a destination
port mask.
•
src port mask – Specify a TCP port mask for the source port in hex form (hex 0x0-
0xffff), which you wish to filter.
260