Q-In-Q; Q-In-Q Settings - D-Link xStack DGS-3400 Series Reference Manual

®
x Stack DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch

Q-in-Q

Q-in-Q is designed for service providers to carry traffic from multiple users across a network. Q-in-Q is used to maintain customer
specific VLAN and Layer 2 protocol configurations even when the same VLAN ID is being used by different customers. This is
achieved by inserting SP-VLAN tags into the customer's frames when they enter the service provider's network, and then
removing the tags when the frames leave the network.
Customers of a service provider may have different or specific requirements regarding their internal VLAN IDs and the number of
VLANs that can be supported. Therefore customers in the same service provider network may have VLAN ranges that overlap,
which might cause traffic to become mixed up. So assigning a unique range of VLAN IDs to each customer might cause
restrictions on some of their configurations requiring intense processing of VLAN mapping tables which may exceed the VLAN
mapping limit. Q-in-Q uses a single service provider VLAN (SP-VLAN) for customers who have multiple VLANs. Customer's
VLAN IDs are segregated within the service provider's network even when they use the same customer specific VLAN ID.
Q-in-Q expands the VLAN space available while preserving the customer's original tagged packets and adding SP-VLAN tags to
each new frame.

Q-in-Q Settings

This function allows the user to enable or disable the Q-in-Q function on the Switch.
To view this window click L2 Features > QinQ > QinQ Settings, as shown below:
Figure 3 - 74 Q-in-Q Settings window
228