Ipv6 Interface Settings; Ipv6 Route Table - D-Link DGS-3200 Series User Manual

IPv6 Interface Settings

To configure the Switch's IPv6 interface settings:
Open the Configuration folder and click IPv6 Interfaces Settings. The web manager will display the Switch's current IPv6
interface settings in this window, as displayed below.
To configure IPv6 interface settings, enter an Interface Name, a VLAN Name, and make sure the Interface Admin. State is
Enabled. Click the Create button. The new entry will appear in the Interface Table at the bottom of the window.
To modify an Interface Table entry, click the corresponding Edit button. The following window opens:
After making the desired changes, click the Apply button.
The following parameters may be configured or viewed:
Parameter Description
Enter the name of the IPv6 interface.
Interface Name
Enter the VLAN name of the IPv6 interface.
VLAN Name
Interface Toggle the state between Enabled and Disabled.
Admin. State
Active This read-only field indicates the status of this entry.
IPv6 Address Enter the IPv6 address of the interface to be modified.

IPv6 Route Table

To configure the Switch's IPv6 Route Table address:
Open the Configuration folder and click IPv6 Route Table.
Enter a value in the Gateway field and click the Create button.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Figure 6- 5. IPv6 Interface Settings window
Figure 6- 6. IPv6 Interface Settings (Edit) window
Figure 6- 7. IPv6 Route Table window
32