Ip Multicast Vlan Replication Settings - D-Link xStack DGS-3400 Series Reference Manual

x Stack
The following fields may be set:
Parameter
IP Multicast VLAN
Replication State
TTL
Source MAC
Address
Click Apply to implement changes.

IP Multicast VLAN Replication Settings

This window allows the user to create an IP Multicast VLAN replication entry. An IP Multicast VLAN Replication entry defines
what traffic will be replicated and how the packet will be replicated.
To view this window, click Administration > IP Multicast VLAN Replication > IP Multicast VLAN Replication Settings, as
shown below.
Figure 2 - 147 IP Multicast VLAN Replication Settings window
Enter a name for the IP Multicast Replication entry and click Apply. The new entry will appear in the IP Multicast VLAN
Replication Entries Table.
The user can then configure the Source settings by clicking the corresponding View buttons , as shown below.
This table is used to configure the traffic to be replicated by the IP Multicast VLAN replication entry. The traffic is described by a
source VLAN, a list of Multicast Group addresses and an optional source IP address associated with the multicast group.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Description
Enable or Disable the IP Multicast VLAN Replication State on the Switch.
TTL specifies whether to decrease the time to live of a packet, the user can choose either
Decrease or No Decrease. When a multicast packet is forwarded across VLANs, the time to
live will be decreased by one. If No Decrease is specified, the time to live will not be
decreased. By default, TTL will be decreased.
Specifies whether to replace the source MAC address of a packet, the user can choose either
Replace or No Replace. By default, the source MAC address will be replaced.
127