Ip Multicast Profile Settings - D-Link DGS-3200 Series User Manual

Parameter
VID (VLAN ID)
VLAN Name
Leave Timer
Host Timeout
Router Timeout
State
Click Apply to implement the new settings.

IP Multicast Profile Settings

The IP Multicast Profile Settings window allows the user to add a profile to which multicast address(es) reports are to be
received on specified ports on the Switch. This function will therefore limit the number of reports received and the number of
multicast groups configured on the Switch. The user may set an IP Multicast address or range of IP Multicast addresses to accept
reports (Permit) or deny reports (Deny) coming into the specified switch ports. To configure the IP Multicast Profile settings, click
L2 Features > IGMP Snooping > IP Multicast Profile Settings:
The following fields can be set:
Parameter Description
Enter a Profile ID between 1 and 24.
Profile ID
Profile Name Enter a name for the IP Multicast Profile.
To change an entry, click the corresponding Modify button in the Multicast Address List column. The Multicast Address Group
List Settings window opens. To edit the name of an entry, click the corresponding Edit button in the Edit Profile Name column.
To remove an entry, click the corresponding Delete button.
DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch
Description
This is the VLAN ID that, along with the VLAN Name, identifies the VLAN the user
wishes to modify the IGMP Snooping Settings for.
This is the VLAN Name that, along with the VLAN ID, identifies the VLAN the user
wishes to modify the IGMP Snooping Settings for.
This specifies the maximum amount of time in seconds between the Switch receiving
a leave group message from a host, and the Switch issuing a group membership
query. If no response to the membership query is received before the Leave Timer
expires, the (multicast) forwarding entry for that host is deleted. The default setting is
2 seconds.
This is the maximum amount of time in seconds allowed for a host to continue
membership in a multicast group without the Switch receiving a host membership
report. Default = 260.
This is the maximum amount of time in seconds a route is kept in the forwarding
table without receiving a membership report. Default = 260.
Select Enabled to implement IGMP Snooping. This field is Disabled by default.
Figure 7- 19. IP Multicast Profile Settings window
90