IBM R30 Operator's Manual page 274

display and change diagnostic test list service
aid, 9-10
display diagnostic run time options task, 9-2
display or change configuration or vital product
data, 9-9
display or change key modes, 9-11
display previous diagnostic results, 9-11
display test patterns, 9-11
display/alter bootlist, 9-9
for use with ethernet, 9-14
generic microcode download, 9-11
hardware error report, 9-12
list, 9-3
local area network, 9-12
microcode download, 9-12
multiprocessor, 9-12
periodic diagnostics, 9-13
process supplemental media task, 9-3
product topology, 9-13
run error log analysis task, 9-2
running diagnostics task, 9-2
SCSI bus, 9-13
SCSI tape utilities, 9-14
SSA, 9-15
trace, 9-15
service aids for use with ethernet, 9-14
service hints service aid, 9-15
Service Line Speed Parameter, 3-37
service position, 2-5
services aids, 7318 serial communications network
server, 9-16
Set Mode to Normal when Booting Flag, 3-36
setting the write-protect tab
1/4-inch tape cartridge, 2-20
3.5-inch diskette, 2-11
4 mm tape cartridge, 2-36
8 mm tape cartridge, 2-26
setting voltage margins, 3-20, 3-33
shutdown command, 7-3
SSA service aid, 9-15
starting the -48 V dc rack, 7-1
starting the AC rack, 5-1
manually, 5-1
methods, 5-1
programmed after power failure, 5-1
programmed by date and time, 5-1
remotely, 5-1
starting the DC rack, 7-2
status light states
4.0GB 4 mm tape drive, 2-38
X-10
Operator Guide
5.0GB 8 mm tape drive, 2-30
status light, 1/4-inch tape drive, 2-19
status lights
4.0 GB 4 mm tape drive, 2-38
5.0GB 8 mm tape drive, 2-29
stopping
immediately
AC rack containing PDB, 5-10
AC rack containing PDU, 5-8
ordinary conditions
-48 V dc rack, 7-3
AC rack containing PDB, 5-9
AC rack containing PDU, 5-7
stopping the -48 V dc rack, 7-3
stopping the AC rack, 5-7
stopping the AC rack, ordinary conditions
containing a PDB, 5-9
containing a PDU, 5-7
stopping the DC rack immediately, 7-4
stopping, immediately, AC rack containing PDB,
5-8
supplies
descriptions, D-1
ordering information, D-1
part numbers, D-1
system power states, F-1
system unit
-48 V dc rack, 6-1
power cables, 6-3
system unit cables, CPU enclosure, 6-3
system verification procedure
additional verification, 10-3
considerations, 10-1
loading diagnostic programs, 10-2
running, 10-2
stopping the diagnostics, 10-3
SystemGuard
BUMP overview, 3-2
common tasks, 3-39
authorize the service console, 3-43
boot from network, 3-52
boot from SCSI device, 3-49
disable processors, 3-55
enable processors, 3-55
enable surveillance, 3-46
reboot AIX from remote service console, 3-48
set fast IPL, 3-40
set the electronic key, 3-39
set the service line speed, 3-42