IBM R30 Operator's Manual page 134

Cable Path
Note: It is recommended that a trained service representative connect or disconnect any
cables attached to the CPU enclosure.
However, if you choose to connect or disconnect cables attached to the system unit,
observe the following information.
Use the cable restraint strap located on an attachment holes on the sides of the rack to
attach the cables to the rack.
To open the cable restraint strap, press the release tab while pulling the end of the cable
restraint strap through the locking mechanism.
To attach the cables to the rack, do the following:
1. Open the cable restraint strap.
2. To attach adapter cables to the rack, gather the cables attached to the adapters, and
then place the cable bundle in the cable restraint strap located below the adapters on
your left.
To attach optional adapter cables to the rack, gather the cables attached to the optional
adapters, and then place the cable bundle in the cable restraint strap located below the
optional adapters on your right.
3. Place the end of the cable restraint strap through the locking mechanism, and then pull
the end of the cable restraint strap to tighten the cables against the rack.
Opening the Cable Restraint Strap
Locking
Mechanism
Closing the Cable Restraint Strap
Locking
Mechanism
4-12
Operator Guide
Release
Tab
Release
Tab
Rear View of Rack
Adapters
Cable
Restraint
Straps