IBM R30 Operator's Manual page 176

Run Diagnostics Task
The Run Diagnostics task invokes the Resource Selection List menu. When the commit key
is pressed, Diagnostics are run on all selected resources.
The procedures for running the diagnostics depends on the states of the Diagnostics Run
Time Options. The run time options are:
Display Diagnostic Mode Selection Menus
If this option is on, the Diagnostic Mode Selection Menu is displayed when the commit
key is pressed.
Include Advanced Diagnostics
If this option is on, Advanced Diagnostics is included.
Include Error Log Analysis
If this option is on, Error Log Analysis will be included. When running Standalone
Diagnostics with Include Error Log Analysis set to Yes, ELA is only done on the error that
is logged in NVRAM.
Run Tests Multiple Times
If this option is on, diagnostic is run in loop mode. This option is only valid when running
Online Diagnostics in Service Mode.
Run Error Log Analysis Task
The Run Error Log Analysis task invokes the Resource Selection List menu. When the
commit key is pressed, Error Log Analysis will be run on all selected resources.
Display or Change Diagnostic Run Time Options Task
The Display or Change Diagnostic Run Time Options task allows the diagnostic run time
options to be set.
Note: The run time options are used only when running the Run Diagnostic task.
The run time options are:
Display Diagnostic Mode Selection Menus
This option allows the user to select whether the DIAGNOSTIC MODE SELECTION
MENU is displayed or not (the default is yes).
Include Advanced Diagnostics
This option allows the user to select if the Advanced Diagnostics should be included or
not (the default is no).
Include Error Log Analysis
This option allows the user to select if the Error Log Analysis (ELA) should be included or
not (the default is no).
Note: When running Standalone Diagnostics with Include Error Log Analysis set to Yes,
ELA is only done on the error that is logged in NVRAM.
9-2
Operator Guide