Location Code Format For Non-Scsi Devices; Non-Scsi Drawer Id Label - IBM R30 Operator's Manual

Location Code Format for Non-SCSI Devices

The following example is for non-SCSI devices. These include planars, memory cards,
adapters, and async distribution boxes.
Use the example to determine the physical location of a device.
Note: The G and H fields each can contain one, two, or three characters.
AB - CD - EF - GH

Non-SCSI Drawer ID Label

This label contains a two-digit number that identifies the slot in the 7015 CPU Enclosure
where the adapter that controls the drawer is located. The number on this label corresponds
to the characters AB in the location code. One label is located in the lower-right corner on
the back of each drawer.
4-18
Operator Guide
Async port number or FRU location on a card or planar.
Connector number on an adapter or planar.
Slot number of the adapter, memory card, or adapter for
the identified device
System I/O bus identifier.
Always 0 on workstations. Drawer ID or slot number of the
adapter that drives the drawer in a rack-type system unit.
Always 0.